Mechanical Hand

No support material needed.

What You Will Need
=
-x20 M4-8 Screws
-x15 M3-16 Screws
-x15 M3 Nuts
-x5 Rubberbands
-x5 Drinking Straws
-x1 1" PVC pipe
-Fishing Wire/ Beading string
-Foam Paper

What to print
=
-x1 of everything except:
-x3 of Middle-Index-Ring 1,2&3
-x20 Washer
-x5 Finger_Hold
-To print the "Finger_Hold" measure the diameter of the tip of you finger rounding up to the nearest mm. Scale the ring to whatever the diameter of the finger is. ex: if your finger is 11.4 mm round up to twelve and scale it x12.

Preparing parts
=
-sand down the top edges of the finger sections to avoid breaking the rubber band.
- To print the "Finger_Hold" at the correct size measure the diameter of the tip of you finger rounding up to the nearest mm. Scale the ring to whatever the diameter of the finger is. ex: if your finger is 11.4 mm round up to twelve and scale it x12.
-This works because the inner hole is 1 mm

Assembly
=
-Connect the finger secti