Mechano-23-CS

Print the boxes, ports, and crossover boards for the outstanding XMechanik Mechano-23 speakers. Details on the overall construction are found here and their measurements are available on both ASR and on Spinorama. The sound quality you can get out of $~300 is incredible. A few notes on printing:If you use the xover boards, make sure to print with no top/bottom walls. The infill acts like a “perf board” to let you put the component wires through and do point-to-point soldering. PETG and PLA should work fineFor the main box, it's setup to print 2 halves with the driver holes up. I did this in PETG having tested the resonance properties of a few materials. This worked a lot better than slicing horizontally and stacking 4-8 pieces. Note the triangular ridges in each part of the box. They're there to stiffen the walls . They're triangular to let you avoid needing supports on them. The 29 degree support angle and painting of them was chosen for this.A few people have altered the