Thingiverse
Melzi to Trigorilla
door dtylerb
0
Downloads
1
Likes
0
Makes
These are the parts I used to install a Trigorilla board (from an Anycubic i3 Mega S) in to a Monoprice Maker Select V1 that originally comes with a Melzi board. It should also work on the V2, the Wanhao Duplicator i3, and the Cocoon Create, as I understand these are all the same printer. This allowed me to run the latest version of Marlin and solve the thermal runaway issue inherent to the original firmware.
The bracket is split in to two parts because as one piece it was too long to fit on my build plate. The two halves get attached together by attaching them to the included spacers using M3 screws. It actually wouldn't hurt for you to make some more spacers to glue on to other parts of the bracket to decrease the ability for it to flex when pushing down on the board.
Finally, there is a custom backplate that will give you access to the USB port on the Trigorilla board. I had to rearrange the positioning of the fan and the plug/switch to make everything fit. Also, the area I've
The bracket is split in to two parts because as one piece it was too long to fit on my build plate. The two halves get attached together by attaching them to the included spacers using M3 screws. It actually wouldn't hurt for you to make some more spacers to glue on to other parts of the bracket to decrease the ability for it to flex when pushing down on the board.
Finally, there is a custom backplate that will give you access to the USB port on the Trigorilla board. I had to rearrange the positioning of the fan and the plug/switch to make everything fit. Also, the area I've
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
