Metallica St. Anger

Project: St. AngerPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Base Thickness of 0.48mmThe Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mm #000000 PLA BambuLab Basic Black Transmission Distance: 0.6 #c00d1e PLA BambuLab Basic Red Transmission Distance: 4 #ff6a13 PLA BambuLab Basic Orange Transmission Distance: 3 #9b9ea0 PLA BambuLab Matte Ash Gray Transmission Distance: 1.5This print uses 4 unique filamentsSwap Instructions: Start with Black At layer #10 (0.88mm) swap to Red At layer #19 (1.6mm) swap to Orange At layer #24 (2mm) swap to Ash Gray for the rest. Note: I use Bambu PLA for all of my prints. If you substitute different brand filaments, the result might not look the same due to different filament transmission distances.