Thingiverse
Micro ATX Form Factor case
por daveo17aus
40
Descargas
29
Likes
0
Makes
can be printed in 140mm dia x 250 high you will require super glue,case screws x2,10mm motherboard standoffs , 2x small hinges
power supply is mounted on top over the large hole fan down with double sided tape.
attach hinges to the blank side ram side
should have photos in a couple of weeks 11/02/18
any suggestions are welcome will be designing a few different options in the future more pci slots, extra bracing maybe a second level.
power supply is mounted on top over the large hole fan down with double sided tape.
attach hinges to the blank side ram side
should have photos in a couple of weeks 11/02/18
any suggestions are welcome will be designing a few different options in the future more pci slots, extra bracing maybe a second level.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
