Thingiverse
Micro Camera Canopy
von PB3DCreations
152
Downloads
118
Likes
2
Makes
Micro Camera Canopy for Micro brushless builds with a 20x20 Flight Controller Stack. Sits on top of the stack and can be secured with M3 Nylon or Stainless steel nuts.
• Fits 20x20mm Flight Controller Stack
• Adjustable angle for both pod and Camera provided full protection in every angle
• Room for VTX03 or similar micro VTX behind camera
• Small cavity above camera for linear antenna or other wires
**Donating a tip allows us to keep releasing designs like this one and making improvements down the road to current designs!
• Fits 20x20mm Flight Controller Stack
• Adjustable angle for both pod and Camera provided full protection in every angle
• Room for VTX03 or similar micro VTX behind camera
• Small cavity above camera for linear antenna or other wires
**Donating a tip allows us to keep releasing designs like this one and making improvements down the road to current designs!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
