Thingiverse
Micro SD Card Stackable Storage
27
Downloads
10
Likes
1
Makes
# Micro-SD Card Holder #
1. Print at least one holder
2. Print one lid
3. Place SD Cards inside
4. Use the lid
I couldn't believe that I couldn't find a microSD card holder that I liked on here. I took a few minutes and designed what I had in mind. The spacing between the cards is enough that you should be able to remove your card without tweezers.
The bases are stackable. Just two stacks will retain 10 cards. It may not be clear from the picture, but the bases actually clip together along with the lid. These features were designed to be retaining so that nothing falls out.
1. Print at least one holder
2. Print one lid
3. Place SD Cards inside
4. Use the lid
I couldn't believe that I couldn't find a microSD card holder that I liked on here. I took a few minutes and designed what I had in mind. The spacing between the cards is enough that you should be able to remove your card without tweezers.
The bases are stackable. Just two stacks will retain 10 cards. It may not be clear from the picture, but the bases actually clip together along with the lid. These features were designed to be retaining so that nothing falls out.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!