Thingiverse
Micro SD case - 12 slots
door Redmagemaker
5
Downloads
1
Likes
0
Makes
PLEASE READ BEFORE PRINTING!
These parts are purposely designed with very tight tolerances and are intended to be sanded to a finished fit. The lid part file is only 1/2mm larger per side to ensure that the part would not come out too loose. Using a very fine grit, just lightly sand the exterior walls of the base part, not the interior walls of the lid. A light smoothing is all it needs to be a snug, but easy to remove fit.
In the photos it may appear as if there is a gap between the lid and base, but that is only because I accidently rounded the edges of the lip around the base as I was sanding the part.
The overall dimensions of the box with lid on: W 17.5mm X L 36.5mm X H 24.5mm
These parts are purposely designed with very tight tolerances and are intended to be sanded to a finished fit. The lid part file is only 1/2mm larger per side to ensure that the part would not come out too loose. Using a very fine grit, just lightly sand the exterior walls of the base part, not the interior walls of the lid. A light smoothing is all it needs to be a snug, but easy to remove fit.
In the photos it may appear as if there is a gap between the lid and base, but that is only because I accidently rounded the edges of the lip around the base as I was sanding the part.
The overall dimensions of the box with lid on: W 17.5mm X L 36.5mm X H 24.5mm
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
