Thingiverse
Micro SD extension cable
von Oparie
4
Downloads
3
Likes
0
Makes
Just a bespoke Micro SD extension holder.
I happen to buy an odd sized, shaped and naked Micro SD card extension cable (picture 2). Found no holder here on Thingiverse. So designed this one sided holder (picture 1 and 3) to put it aside my Anet A6 display (pictures 4, 5 and 6). It was easy to route the cable behind the display cover. I designed holes for four M3 screws, but two seemed enough.
If you happen to have the same Micro SD extension cable you are the lucky.
I happen to buy an odd sized, shaped and naked Micro SD card extension cable (picture 2). Found no holder here on Thingiverse. So designed this one sided holder (picture 1 and 3) to put it aside my Anet A6 display (pictures 4, 5 and 6). It was easy to route the cable behind the display cover. I designed holes for four M3 screws, but two seemed enough.
If you happen to have the same Micro SD extension cable you are the lucky.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!