Thingiverse
micro sd holder
von dav88
1
Downloads
3
Likes
0
Makes
micro sd holder for micro sd extension for cr 10.
its held to a 3/4 in. table via a screw.
you slide the male end into the front slot of the holder and out, then up through the bottom
into the rear and up and out and over to the cr10 micro sd input slot.
i modeled it for this one from amazon. https://www.amazon.com/gp/product/B00DG1DBZ6/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1
the pictures on amazon dont show the cover on the female end, but it came with a nice black case for the female end.
* i made it thicker at the bottom to make it stronger.
its held to a 3/4 in. table via a screw.
you slide the male end into the front slot of the holder and out, then up through the bottom
into the rear and up and out and over to the cr10 micro sd input slot.
i modeled it for this one from amazon. https://www.amazon.com/gp/product/B00DG1DBZ6/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1
the pictures on amazon dont show the cover on the female end, but it came with a nice black case for the female end.
* i made it thicker at the bottom to make it stronger.
dav88 veröffentlicht auch auf
537 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
