Thingiverse
Micro Vacuum Attachments
von poikilos
5
Downloads
4
Likes
0
Makes
These attachments work with a U.S. vacuum cleaner (friction fit end, not odd/upright vacuums with different diameters).
In addition to adapting the included tool ends, the included adapter also adapts a U.S. vacuum to 3/8 inch (9.525mm) OD hose such as EZ-FLO model #98617 vinyl tubing.
Abbreviations:
- outer diameter (OD)
- inner diameter (ID)
If you have any other diameters that should be added, just tell me in the comments. I was unable to find dimensions to make this compatible with existing mini ends, so this is only compatible with itself and a 1/4 inch ID hose.
The holes in side prevent putting too much load on the vacuum. If the airway is too small, the vacuum cleaner could overheat, so keep the holes open to prevent that.
## License
- [Creative Commons - Attribution](https://creativecommons.org/licenses/by/4.0/) (CC BY 4.0)
- by Poikilos.org https://www.thingiverse.com/poikilos
[support me](https://flattr.com/@Poikilos)
In addition to adapting the included tool ends, the included adapter also adapts a U.S. vacuum to 3/8 inch (9.525mm) OD hose such as EZ-FLO model #98617 vinyl tubing.
Abbreviations:
- outer diameter (OD)
- inner diameter (ID)
If you have any other diameters that should be added, just tell me in the comments. I was unable to find dimensions to make this compatible with existing mini ends, so this is only compatible with itself and a 1/4 inch ID hose.
The holes in side prevent putting too much load on the vacuum. If the airway is too small, the vacuum cleaner could overheat, so keep the holes open to prevent that.
## License
- [Creative Commons - Attribution](https://creativecommons.org/licenses/by/4.0/) (CC BY 4.0)
- by Poikilos.org https://www.thingiverse.com/poikilos
[support me](https://flattr.com/@Poikilos)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
