Thingiverse
Microbit breakout
door fm1
41
Downloads
27
Likes
0
Makes
This is a first attempt at a Microbit breakout connector.
I was aware that the GPIO pins on the Microbit are too narrow to fit jumper wires on one side of the board so I tried to make a row on the other side of the board - only then discovered the pins only function on the front of the board! So, half the pins are functional - doh!
The model can obviously be edited to provide jumper pin sockets for needed pins
I was aware that the GPIO pins on the Microbit are too narrow to fit jumper wires on one side of the board so I tried to make a row on the other side of the board - only then discovered the pins only function on the front of the board! So, half the pins are functional - doh!
The model can obviously be edited to provide jumper pin sockets for needed pins
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!