Thingiverse
Microburner Mounting Bracket Extras
von CanadianBaconPro
0
Downloads
0
Likes
0
Makes
Driftrotor did an amazing job at reworking the Stealthburner to fit the Micro Swiss Direct Drive upgrade. After printing one out for my CR-10 I realized there was no bracket for the BLTouch, so I reworked the provided one.
EDIT: Driftrotor has since released the CR-Touch bracket, I would recommend using theirs over mine as I'm a complete noob in CAD.
I also saw in the comments of the original project that a no-probe bracket would be provided so I added one while working on the BLTouch Mount.
The BLTouch mount is designed to use M3x5 bolts with heat set M3 nuts. Use a low temperature when setting the nuts to prevent the mount from bending.
This is currently untested but will be shortly, updates to come if needed!
The needed fans and bolts that aren't listed in Driftrotors original post can be found here:
Voron (StealthBurner) BOM: https://vorondesign.com/sourcing_guide?model=VSB
EDIT: Driftrotor has since released the CR-Touch bracket, I would recommend using theirs over mine as I'm a complete noob in CAD.
I also saw in the comments of the original project that a no-probe bracket would be provided so I added one while working on the BLTouch Mount.
The BLTouch mount is designed to use M3x5 bolts with heat set M3 nuts. Use a low temperature when setting the nuts to prevent the mount from bending.
This is currently untested but will be shortly, updates to come if needed!
The needed fans and bolts that aren't listed in Driftrotors original post can be found here:
Voron (StealthBurner) BOM: https://vorondesign.com/sourcing_guide?model=VSB
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
