Thingiverse
Microcube RaspberryPi-Octoprint Mount
von Eddiie
5
Downloads
3
Likes
0
Makes
This is a hacked together Raspberry Pi 3B mount for the Microcube.
I will probably remix it to move the mounts to the other side so it can be used with a 3.5 inch display to the left of the LCD display for the RAMPS.
I am using ebay item # 381374423467 to convert 12v to 5V, will finish up installing later - plan to remove the USB connector, solder on some jumper wires and attach to RaspberryPi GPIO pins to power then stow it under the HDMI connector.
I will probably remix it to move the mounts to the other side so it can be used with a 3.5 inch display to the left of the LCD display for the RAMPS.
I am using ebay item # 381374423467 to convert 12v to 5V, will finish up installing later - plan to remove the USB connector, solder on some jumper wires and attach to RaspberryPi GPIO pins to power then stow it under the HDMI connector.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!