Thingiverse
Micromake Delta Upgrades
by christtian
45
Downloads
30
Likes
3
Makes
These are some upgrades I made for my Micromake D1 delta printer.
First, two overhanging spoolholders corresponding to 1Kg and 450g spools (nylon for example). They works fine !
Secondly, a bed holder adapted to the micromake D1. This is a remix I modified to not block the printer head on the periphery of the bed. I have put 4 of them, 2 up, 2 down. You can use the extra screws from the kit (shorts M3 and M4). It will give the ability to remove the glass bed in 2 seconds to change the rubber or take of a print.
Thirdly, a simple wire bearing for the printer head to attach the wires regardless the PFE tube. I use mirror double sided rubber to fix it.
Print best with 0.2 layer and 15-20% infill to ensure rigidity, PLA.
I use Repetier Host version 1.6.2 to run this printer. Unfortunately last version 2.0.1 really doesn't work with it.
First, two overhanging spoolholders corresponding to 1Kg and 450g spools (nylon for example). They works fine !
Secondly, a bed holder adapted to the micromake D1. This is a remix I modified to not block the printer head on the periphery of the bed. I have put 4 of them, 2 up, 2 down. You can use the extra screws from the kit (shorts M3 and M4). It will give the ability to remove the glass bed in 2 seconds to change the rubber or take of a print.
Thirdly, a simple wire bearing for the printer head to attach the wires regardless the PFE tube. I use mirror double sided rubber to fix it.
Print best with 0.2 layer and 15-20% infill to ensure rigidity, PLA.
I use Repetier Host version 1.6.2 to run this printer. Unfortunately last version 2.0.1 really doesn't work with it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
