Thingiverse
Gadgets
Go to Model
Microphone Desk Boom
177
Downloads
169
Likes
0
Makes
This is an almost fully printable microphone desk boom. The non printed hardware needed is:
•2X Hex Head Screw 1/4"-20 Thread Size, 1-1/2" Long (7/16" Hex)
•2X Nylon-Insert Locknut 1/4"-20 Thread Size (7/16" Hex)
I ended up not using the screw caps and instead used real tools to tighten the bolts as it was too difficult by hand.
To assemble:
1) Insert post into clamp and secure with post key.
2) Press fit post extender into the first post if additional height is desired
3) Assemble the rest of the setup according to the provided pictures
•2X Hex Head Screw 1/4"-20 Thread Size, 1-1/2" Long (7/16" Hex)
•2X Nylon-Insert Locknut 1/4"-20 Thread Size (7/16" Hex)
I ended up not using the screw caps and instead used real tools to tighten the bolts as it was too difficult by hand.
To assemble:
1) Insert post into clamp and secure with post key.
2) Press fit post extender into the first post if additional height is desired
3) Assemble the rest of the setup according to the provided pictures
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
