Thingiverse
Minecraft Mace
von JacobinPigeon
2
Downloads
7
Likes
0
Makes
This mace is 226.3 mm.
This mace is only the front half of a mace and should be printed twice to get the full mace. There are small divots in the back of the mace to put glue in when putting the 2 halves together.
The mace is pretty small and should be upscaled about 2x to get to full size.
This mace is only the front half of a mace and should be printed twice to get the full mace. There are small divots in the back of the mace to put glue in when putting the 2 halves together.
The mace is pretty small and should be upscaled about 2x to get to full size.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
