Thingiverse
Minecraft Nightlight
por dparrish
23
Descargas
17
Likes
0
Makes
These are the parts for the Minecraft Nightlight I built for my daughter.
Built around an Arduino with accelerometer to detect when it's picked up, and LEDs for lighting up the room.
The Base Station is to contain a wireless charging module with alignment magnets so the cube can be left on charge when it's not being carried.
I printed this on a single extruder printer so the walls of the cube are done in two pieces, one solid and one in clear PLA that clips into the solid piece. I've included STL files for those with a multi-extruder printer to avoid having to friction fit pieces.
This project has been build and works just fine, but marked as WIP since I haven't yet finished the write-up.
Built around an Arduino with accelerometer to detect when it's picked up, and LEDs for lighting up the room.
The Base Station is to contain a wireless charging module with alignment magnets so the cube can be left on charge when it's not being carried.
I printed this on a single extruder printer so the walls of the cube are done in two pieces, one solid and one in clear PLA that clips into the solid piece. I've included STL files for those with a multi-extruder printer to avoid having to friction fit pieces.
This project has been build and works just fine, but marked as WIP since I haven't yet finished the write-up.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!