Thingiverse
Minecraft Pig
von MakeNotBuy
38
Downloads
23
Likes
1
Makes
stl. was created by my 10 yo son using sketchup.
I helped him configure cura with target less support than possible.
We used glue stick to increase adhesion.
Please reduce print speed till both legs are joined, because model is not stable.
I paused printing and put some gaffer tape to fix legs.
Model is quite big, we scaled to 30% for printing.
I helped him configure cura with target less support than possible.
We used glue stick to increase adhesion.
Please reduce print speed till both legs are joined, because model is not stable.
I paused printing and put some gaffer tape to fix legs.
Model is quite big, we scaled to 30% for printing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
