Thingiverse
Mini Air Filtration System
von xjuls
71
Downloads
47
Likes
0
Makes
This is an experiment for now... 3D Print enclosure for a 120 mm 110 CFM fan using a respirator mask filter to filter the air of my garage.
DIY 20-inch box fan solution is too loud, blows too much air in the winter. Curious if using smaller/quieter fans with different configurations can be just as useful while taking significantly less space in a smaller workshop.
So far this has shown lots of promise as an overnight setup preventing dust from settling on my equipment.
Total cost: $22.00.
1. 3M Particulate Filter 2091, P100
$7.00
2. AC Infinity AXIAL 1238, Muffin Fan, 115V 120V AC 120mm x 38mm High Speed, for DIY Cooling Ventilation Exhaust Projects by AC Infinity
$15.00 ea
DIY 20-inch box fan solution is too loud, blows too much air in the winter. Curious if using smaller/quieter fans with different configurations can be just as useful while taking significantly less space in a smaller workshop.
So far this has shown lots of promise as an overnight setup preventing dust from settling on my equipment.
Total cost: $22.00.
1. 3M Particulate Filter 2091, P100
$7.00
2. AC Infinity AXIAL 1238, Muffin Fan, 115V 120V AC 120mm x 38mm High Speed, for DIY Cooling Ventilation Exhaust Projects by AC Infinity
$15.00 ea
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
