Thingiverse
Mini Dal3
von Frostgear
6
Downloads
1
Likes
0
Makes
This is a low profile plastic ant wedge bot. Its invertible and went 3-2 at tap room tapout.
Parts used:
fs2a receiver
2s lipo
4 LEGO Parts - Black Tire 30.4 x 14
4 N20 motors
Dual Way Bidirectional ESC 2S-3S 5A Brushed ESC Speed Controller for 16:1 RC
led light
on off switch
Plate print x 2
Body print x1
Wedgelet print x6
Wheel print x4
6 small zipties
8 M3 heat set threaded inserts
8 M3 computer screws
bit of hot glue at the back of each motor
Parts used:
fs2a receiver
2s lipo
4 LEGO Parts - Black Tire 30.4 x 14
4 N20 motors
Dual Way Bidirectional ESC 2S-3S 5A Brushed ESC Speed Controller for 16:1 RC
led light
on off switch
Plate print x 2
Body print x1
Wedgelet print x6
Wheel print x4
6 small zipties
8 M3 heat set threaded inserts
8 M3 computer screws
bit of hot glue at the back of each motor
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
