MakerWorld
Decor
Ver Modelo
Mini Drape Vase
28
Descargas
14
Likes
18
Makes
Note: this prints in vase mode and therefore does not reliably hold water. I did a water test with this printed on my P1S and it did hold water with only a few drips seeping out after 3 days, but for reliability in holding water, please print the larger version of my drape vase. This is best suited for dried or fake flowers. A small vase for a few small flowers. It is less than 4g and prints in about half an hour
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!