Mini Drone LEM (Lunar Excursion Module)

This little LEM tribute model is fun (and fragile) to fly. [Video](https://youtu.be/daK1i-0VSSs)

Because it's based on the [TXD-G1 mini drone](https://www.ebay.com/itm/TXD-G1-Foldable-Mini-RC-Drone-WiFi-Camera-720-HD-One-Key-Takeoff-UAV-3-colors/183542842007?ssPageName=STRK%3AMEBIDX%3AIT&var=690897842955&_trksid=p2057872.m2749.l2649) it will only give you a couple minutes of flight time. I'm going to try it with the non-camera version to see if the flight times increase and I may try adapting a larger battery to see if that helps give it more duration.

Depending on the filament you use - it may not survive a bad landing. I found the groovey looking gold filament to be more brittle than regular PLA.

- It requires CA glue and a couple of heavy duty paperclips.
- The frame can be printed without supports but that may vary depending on how good your printer is at doing bridges.
- The dish section just snaps on.
- The Legs are hollow so you can insert the heavy duty paperclip