Thingiverse
Mini Flip Switch Case
by Bakke33
24
Downloads
17
Likes
0
Makes
It's a mini flip switch case, with three holes. One on the top(6mm) and one on each side(4mm).
To be used with flip switches that have a 6mm neck diameter.
The case is a cube with 24 mm sides.
The lid is a snap on lid. It should work to press it down and it should be rather stuck.
Recommended layer height is 0.15.
To be used with flip switches that have a 6mm neck diameter.
The case is a cube with 24 mm sides.
The lid is a snap on lid. It should work to press it down and it should be rather stuck.
Recommended layer height is 0.15.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
