Thingiverse
Mini Garbage Bin
von koochdawg
65
Downloads
60
Likes
0
Makes
This is a mini garbage can you can place near your printer to discard filament scraps, bad prints, etc.
I made this to test the limits of my available print space. The original size is 180 mm tall, but could be scaled down for smaller printers.
The handles may cause a little bit of overhang drooping, but you can use supports at the cost of print time.
Good Luck and Thanks!
I made this to test the limits of my available print space. The original size is 180 mm tall, but could be scaled down for smaller printers.
The handles may cause a little bit of overhang drooping, but you can use supports at the cost of print time.
Good Luck and Thanks!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
