Thingiverse
mini itx
by Boom10101
35
Downloads
30
Likes
0
Makes
IMPORTANT! I have found a lot of issues with this design after printing. I will be uploading a V.2 soon.
This case is for a mini itx build.
Holes on front panel are for:
15mm momentary power button
5mm LED holder and LED
screw mount usb ports.
Holes on the back are for:
Mini itx power supply
50mm fan
I/O shield
You will also need a mobo tray. I am temporarily using this one http://www.thingiverse.com/thing:24270 I will update this once I have made one for this case.
There should be room in the bottom for a couple 2.5" drives. I plan to make built in drive holders and will update after I have done so.
In the future I would like to add some cable routing channels, expand the case a bit to house a gpu and an all in one liquid cooler as well as post an unbranded model.
This fits on my i3 with a 200mm x 270mm print bed. Anything smaller than that and it will have to be cut up.
This case is for a mini itx build.
Holes on front panel are for:
15mm momentary power button
5mm LED holder and LED
screw mount usb ports.
Holes on the back are for:
Mini itx power supply
50mm fan
I/O shield
You will also need a mobo tray. I am temporarily using this one http://www.thingiverse.com/thing:24270 I will update this once I have made one for this case.
There should be room in the bottom for a couple 2.5" drives. I plan to make built in drive holders and will update after I have done so.
In the future I would like to add some cable routing channels, expand the case a bit to house a gpu and an all in one liquid cooler as well as post an unbranded model.
This fits on my i3 with a 200mm x 270mm print bed. Anything smaller than that and it will have to be cut up.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!