Thingiverse
Mini Pixel Arch
door fightingosprey
111
Downloads
56
Likes
0
Makes
Simple 20 pixel arch. Designed to fit nicely on my Ender 3.
Arch is 20 cm high and 37 cm wide. About 1 inch spacing between pixels.
Each end of the arch measure 20x20x10 mm.
If you make your own mounts I would recommend a little bit bigger holes than 20x20x10 mm. I made mine 20,5x20x10,5 mm.
Feel free to contact me for suggestions or if you need a special mount.
Update 24.03.21:
Added a 4 part print, Mini_Arch_4parts for smaller printers.
Pieces are a tight fit, but worked ok on my Ender 3 at 0.28mm layer height.
Update 18.07.21:
Added mounts for wooden railing. Fits 48mm by 123mm top rail.
Arch is 20 cm high and 37 cm wide. About 1 inch spacing between pixels.
Each end of the arch measure 20x20x10 mm.
If you make your own mounts I would recommend a little bit bigger holes than 20x20x10 mm. I made mine 20,5x20x10,5 mm.
Feel free to contact me for suggestions or if you need a special mount.
Update 24.03.21:
Added a 4 part print, Mini_Arch_4parts for smaller printers.
Pieces are a tight fit, but worked ok on my Ender 3 at 0.28mm layer height.
Update 18.07.21:
Added mounts for wooden railing. Fits 48mm by 123mm top rail.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
