Mini Pixel Arch

Simple 20 pixel arch. Designed to fit nicely on my Ender 3.
Arch is 20 cm high and 37 cm wide. About 1 inch spacing between pixels.
Each end of the arch measure 20x20x10 mm.
If you make your own mounts I would recommend a little bit bigger holes than 20x20x10 mm. I made mine 20,5x20x10,5 mm.

Feel free to contact me for suggestions or if you need a special mount.



Update 24.03.21:
Added a 4 part print, Mini_Arch_4parts for smaller printers.
Pieces are a tight fit, but worked ok on my Ender 3 at 0.28mm layer height.

Update 18.07.21:
Added mounts for wooden railing. Fits 48mm by 123mm top rail.