Mini Screwdriver for Hex Bits

This is a 3D printable Screwdriver handle with a magnet, for hex bits. I needed a quite small driver, and went ahead and made one a bit bigger. The larger driver is roughly 60 mm tall, while the small one is at 30 mm. The magnet I used was from a pack of 12 at home depot for cheap. Measuring 6.35mm by 1.53mm. Its a very tight fit, no need for glue. I recommend sticking the magnet to the base of a hex bit or to the head of a screw and using a vice to slowly press it in. I printed in PLA+ at 50% infill for strength and they seem to work well with that.