Thingiverse
Mini soap box
por Barbari
27
Descargas
17
Likes
0
Makes
It is a mini size soap box which can take one standard size bath soap standing inside. It has following features:
1. material saving: it is only 60mm*35mm*50mm. It saves more than 50% of material comparing to a normal soap box with soap lying down in it.
2. easy to clean: bottom is detached, and you can reach every corner of it easily.
3. easy to print: same as my other design, no support required.
4. save your soap: small contact surface with mesh bottom, and special water drain, minimize the soap dissolve by water. I put them on shelf in shower, lol, my soap doesn't shrink. Of course if you like a cap, It is also easy to add one for it.
The only problem is that sometimes soap might stuck to bottom mesh, just move the soap back and forth once, then it comes out with no issue.
1. material saving: it is only 60mm*35mm*50mm. It saves more than 50% of material comparing to a normal soap box with soap lying down in it.
2. easy to clean: bottom is detached, and you can reach every corner of it easily.
3. easy to print: same as my other design, no support required.
4. save your soap: small contact surface with mesh bottom, and special water drain, minimize the soap dissolve by water. I put them on shelf in shower, lol, my soap doesn't shrink. Of course if you like a cap, It is also easy to add one for it.
The only problem is that sometimes soap might stuck to bottom mesh, just move the soap back and forth once, then it comes out with no issue.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
