Thingiverse
Mini XLR Right Angle Adapter
door Toftylicious
10
Downloads
11
Likes
0
Makes
This is a simple adapter that helps to convert a TA4FX type Mini XLR connector into a low profile right angle version.
These connectors can be found here: https://www.ebay.co.uk/itm/263727125824 (plastic tail female).
The black rear part needs to be cut down to be 7.5mm long, then the cavity needs to be filled with hot glue and the printed part gets pressed into place, while the glue is still hot.
The cable diameter should be 3mm or less for this version.
The connector will no longer be able to be disassembled, without forcing the printed end out and picking out the glue, so it's important that the cable wiring and the orientation of how the cable exits the printed end are done correctly.
These connectors can be found here: https://www.ebay.co.uk/itm/263727125824 (plastic tail female).
The black rear part needs to be cut down to be 7.5mm long, then the cavity needs to be filled with hot glue and the printed part gets pressed into place, while the glue is still hot.
The cable diameter should be 3mm or less for this version.
The connector will no longer be able to be disassembled, without forcing the printed end out and picking out the glue, so it's important that the cable wiring and the orientation of how the cable exits the printed end are done correctly.
Toftylicious publiceert ook op
27 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
