Thingiverse
Pop shield clamp
von splabble
3
Downloads
1
Likes
0
Makes
A threaded pop shield/pop filter clamp designed to replicate the standard clamp that come with cheaper pop shields like the one pictured.
Printed at 0.2mm layer height with 60% infill, plus a 100% infill in a cube around the bolt hole. No supports.
Uses a M4 x 25mm bolt and nut. The nut is optional as the screw should self tap to a degree in the plastic, however this is unlikely to be very strong.
Watch out for excessive elephants foot as this could make it hard to get the pop shield screw in.
Printed at 0.2mm layer height with 60% infill, plus a 100% infill in a cube around the bolt hole. No supports.
Uses a M4 x 25mm bolt and nut. The nut is optional as the screw should self tap to a degree in the plastic, however this is unlikely to be very strong.
Watch out for excessive elephants foot as this could make it hard to get the pop shield screw in.
splabble veröffentlicht auch auf
7 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
