Minimal Slanted Laptop Stand

This model consists of two separate stands (DX and RX) designed to support laptops, tablets, or similar devices at an inclination angle of approximately 15°, improving ergonomics and airflow.The design is minimal and slanted, with no moving parts, focused on stability, simplicity, and a clean desk setup. Important Printing NotesThis model is prone to warping, therefore several precautions have already been included: • Integrated mouse ears on each stand • One model per build plate is strongly recommended • Reduced print speed during the first part of the print to improve initial adhesion Printing RecommendationsTo further minimize warping, I recommend: • Washing the build plate with dish soap and warm water • Drying it thoroughly before printing • Using standard bed adhesion settings in your slicer With these precautions, the print worked reliably in my case. If you print this model and find it useful, a boost would be greatly appreciated.