Thingiverse
Miniware ES120 case
von feletoch
6
Downloads
4
Likes
0
Makes
Case for the Miniware ES120 electric screwdriver
Features:
Holds 18 28mm or shorter bits (+1 with screw driver), design with 3mm holes at bottom to slot-in magnets if bits become too loosen.
Hole to charge screwdriver when case is closed
Hold 1 extended shaft
Multiple slots to add magnet sheet to hold screws when working
Add steps file so you can decide on what you want to change.
Printed with PETG, .2mm 25% adapted cubic and zero supports, hinge need some 1.75 filaments
Features:
Holds 18 28mm or shorter bits (+1 with screw driver), design with 3mm holes at bottom to slot-in magnets if bits become too loosen.
Hole to charge screwdriver when case is closed
Hold 1 extended shaft
Multiple slots to add magnet sheet to hold screws when working
Add steps file so you can decide on what you want to change.
Printed with PETG, .2mm 25% adapted cubic and zero supports, hinge need some 1.75 filaments
feletoch veröffentlicht auch auf
34 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!