Thingiverse
Mirror
von Schmillipp99
0
Downloads
0
Likes
0
Makes
This is a Simple and clean looking mount for a mirror.
It uses threaded caps so you do not see any screws.
It is designed for a 5mm countersunk screw but you can use a smaller screw as well.
my mirror has a thikcness of 3mm if you have a thicker mirror you can just scale up the z dymetion. Just make shure you scale up the lid screw as well.
It uses threaded caps so you do not see any screws.
It is designed for a 5mm countersunk screw but you can use a smaller screw as well.
my mirror has a thikcness of 3mm if you have a thicker mirror you can just scale up the z dymetion. Just make shure you scale up the lid screw as well.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
