Thingiverse
mitus drive block
von davew_tx
0
Downloads
1
Likes
0
Makes
uses an R4 idler bearing and shaft to match
mounts a jhead
needs a PTFE tube between drive and jhead
needs a screw drilled and added to set idler pressure. just set gap once and it doesnt need spring pressure or anything.
m3 screws into Kysan planatary head
mounts a jhead
needs a PTFE tube between drive and jhead
needs a screw drilled and added to set idler pressure. just set gap once and it doesnt need spring pressure or anything.
m3 screws into Kysan planatary head
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
