Thingiverse
moblite canopy
von daoust301
29
Downloads
18
Likes
0
Makes
this is a remix from angry don moblite canopy to add a fin too make the turtle mode easier
lay the model flat on the post and use support to print.
I was able to get my best results with a 0.2mm nozzle
lay the model flat on the post and use support to print.
I was able to get my best results with a 0.2mm nozzle
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
