Thingiverse
Model 3 Front Trunk Leveler
von shanelord
3
Downloads
1
Likes
0
Makes
Front trunk (bonnet) lid on my Model 3 doesn't sit level. Adjusting the screw-in rubber fittings only got me so far.
This sits on the car trim and can be stacked to increase thickness (raised pins with inverse underneath to stop shifting), allowing the screw-in rubber fittings a higher platform to contact raising that side of the front trunk (bonnet) lid.
Automotive tape for bottom, superglue between layers.
Printer is actually a Prusa Mini+
This sits on the car trim and can be stacked to increase thickness (raised pins with inverse underneath to stop shifting), allowing the screw-in rubber fittings a higher platform to contact raising that side of the front trunk (bonnet) lid.
Automotive tape for bottom, superglue between layers.
Printer is actually a Prusa Mini+
shanelord veröffentlicht auch auf
26 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!