Modified Alien Cube

A modified version of 3DSage's Alien cube - https://www.thingiverse.com/thing:1741021


I wanted one with the design on all six faces, and that I could choose the orientation of said faces, so i imported the side piece from his into TinkerCAD, messed around with it a bit, and beveled all the edges so you could rotate it by 90 degrees if you wanted. I also made a mirrored version. Then I made a central block that they would fit onto, and made adjustments to his lid and lid diffuser to make them fit.

i would suggest that you set your printer to have a short z hop on movements, because there are a lot of movements when printing the faces, and i swear i printed about 13 of them before turning z hop on, and they almost all failed, but after i turned it on, i got 5 good ones printed, with no problems other than them needing a bit of a shave when they were done. didn't even need to sand them cause i liked the way that they looked with the concentric surface fill pattern.

All the pa