Thingiverse
Modified C64 case hinges.
von banman
26
Downloads
14
Likes
1
Makes
Modified C64 case hinges.
The 3 cases I have use a slightly different (and weaker) hinge.
This version is 13.5 mm wide and has a slight lip to aid correct alignment of the hinge so that it will connect with the bottom half of the case.
I used hot glue and seem to have adequate results.
All credit goes to the original designer of the C64 case hinge LeftoverBeefcake .
The 3 cases I have use a slightly different (and weaker) hinge.
This version is 13.5 mm wide and has a slight lip to aid correct alignment of the hinge so that it will connect with the bottom half of the case.
I used hot glue and seem to have adequate results.
All credit goes to the original designer of the C64 case hinge LeftoverBeefcake .
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
