Modular 3D Printed Model Rocket

This is the MAPMakER project, which stands for ModulAr Printed ModEl Rocket. The goals of this project are to:
-Design a fully 3d printed, modular model rocket with full parachute recovery system.
-Simple and rapid assembly with no glue required.

It achieves this by connecting the individual parts by screws and threads modified from Nut, Bolt, Washer and Threaded Rod Factory by mike_mattala( https://www.thingiverse.com/thing:193647 )

This system is a work in progress. Right now only the 3 and 4 part configurations are available. Only 18mm motors are supported. I am currently working on 24mm motor compatibility. I also plan on making a special payload nose cone that can house an 808 keychain camera and Jolly Logic Altimeters.

Demo Flights 1 and two:
https://www.youtube.com/watch?v=L41hOa1F4Co
https://www.youtube.com/watch?v=ouKVIZMkeGU&t=14s

Supplies needed for assembly:
-2 or 3 feet of shock cord
-12 inch parachute
-Shock cord mount
-A few drops of super glue/