Thingiverse
Modular Bookstand
2
Downloads
1
Likes
0
Makes
This is a modular bookstand I made to store some books I had laying around. Through the jigsaw tracks on the sides it can connect with other models of itself.
It took around 9 hours to print on my FlashForge Adventurer 3 using a 0.18mm layer height and 3D infill.
The volume of the bookstand is 12cm long, 12 cm wide and 8 cm high, and it can fit around 4 books
It was printed in PLA
It took around 9 hours to print on my FlashForge Adventurer 3 using a 0.18mm layer height and 3D infill.
The volume of the bookstand is 12cm long, 12 cm wide and 8 cm high, and it can fit around 4 books
It was printed in PLA
Materialistic_3D also publishes on
11 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!