Thingiverse
Modular Bookstand
door Materialistic_3D
2
Downloads
1
Likes
0
Makes
This is a modular bookstand I made to store some books I had laying around. Through the jigsaw tracks on the sides it can connect with other models of itself.
It took around 9 hours to print on my FlashForge Adventurer 3 using a 0.18mm layer height and 3D infill.
The volume of the bookstand is 12cm long, 12 cm wide and 8 cm high, and it can fit around 4 books
It was printed in PLA
It took around 9 hours to print on my FlashForge Adventurer 3 using a 0.18mm layer height and 3D infill.
The volume of the bookstand is 12cm long, 12 cm wide and 8 cm high, and it can fit around 4 books
It was printed in PLA
Materialistic_3D publiceert ook op
11 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!