Thingiverse
Modular Electronics Enclosure
por Rconroy
47
Descargas
33
Likes
0
Makes
###Overview
This design is for a modular electronics enclosure for 3D printers. It utilizes a enclosure / tray system, which allows users to create a new tray if different electronics are needed. This configuration is setup to support an Mainboard (MKS Gen L, SKR 1.3, SKR 1.4, SKR 1.4 Turbo, & SKR Mini) , External Mosfet Board, and Raspberry Pi. All Hardware used in this design is M3.
###Revisions
Initial Release - September 5, 2020
Updates to design; Lid closure fasteners from one to three, added stl files for skr mini. - October 25, 2020
###Detailed Description
This design was intended to be fully customization for other users. As it features:
- Simple tray system for mounting all electronics inside the housing
- Simple I/O panels which can be changed
- Mounting locations for the housing on two different sides
- Plastic knock-out features for cable egress
The current configuration uploaded is optimized for:
- MKS Gen L/SKR 1.3/SKR 1.4
- External Mosfet
- Ras
This design is for a modular electronics enclosure for 3D printers. It utilizes a enclosure / tray system, which allows users to create a new tray if different electronics are needed. This configuration is setup to support an Mainboard (MKS Gen L, SKR 1.3, SKR 1.4, SKR 1.4 Turbo, & SKR Mini) , External Mosfet Board, and Raspberry Pi. All Hardware used in this design is M3.
###Revisions
Initial Release - September 5, 2020
Updates to design; Lid closure fasteners from one to three, added stl files for skr mini. - October 25, 2020
###Detailed Description
This design was intended to be fully customization for other users. As it features:
- Simple tray system for mounting all electronics inside the housing
- Simple I/O panels which can be changed
- Mounting locations for the housing on two different sides
- Plastic knock-out features for cable egress
The current configuration uploaded is optimized for:
- MKS Gen L/SKR 1.3/SKR 1.4
- External Mosfet
- Ras
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
