Thingiverse
Modular Hexagonal Drawers
von TR82
17
Downloads
25
Likes
0
Makes
Modular hexagonal drawers default size 200mm(220mm inc knob)x 118mm x 124mm.
Each case has 3 peg holes on every side that can be attached to another case.
Designed to be printed with no support when orientated as shown in the yellow images.
Advised to print the full hex case in low quality to save time. I used a brim for the drawer to prevent warping but everything else is a straight print.
The pegs are strong enough to hold the units together when you print 3 full and 1 half case and arrange as per the photo otherwise you could glue them together for extra strength.
Knobs are designed to be attached using an M4 * 14mm hex socket bolts. Use the bolt to cut a thread into the knob then push the bolt through from the inside of the drawer and thread into the knob. The knob should pull into the recess on the front of each drawer to hold secure.
this is my first Thing and I am self taught in 3d drawing/design so please be nice.
Each case has 3 peg holes on every side that can be attached to another case.
Designed to be printed with no support when orientated as shown in the yellow images.
Advised to print the full hex case in low quality to save time. I used a brim for the drawer to prevent warping but everything else is a straight print.
The pegs are strong enough to hold the units together when you print 3 full and 1 half case and arrange as per the photo otherwise you could glue them together for extra strength.
Knobs are designed to be attached using an M4 * 14mm hex socket bolts. Use the bolt to cut a thread into the knob then push the bolt through from the inside of the drawer and thread into the knob. The knob should pull into the recess on the front of each drawer to hold secure.
this is my first Thing and I am self taught in 3d drawing/design so please be nice.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
