Slicer Discord
Modular Shoe Rack – 3D-Druckmodell von MakerWorld MakerWorld
Footwear

Modular Shoe Rack

von dry3210 · Footwear
8 Downloads
2 Likes
4 Makes
Zum Modell
A modular shoe rack with two leg options (short legs or tall legs). Short leg option is about 107mm tall. Tall leg option is about 127mm.Plate 1: Holder X Large: Fits shoes up to approximately 125mm tall (Most regular boots)Plate 2: Holder Large: Fits shoes up to approximately 110mm tall (Most typical sneakers)Plate 3: Holder Medium: Fits shoes up to approximately 95mm tall (Most lower profile sneakers/dress shoes)Plate 4: Holder Small: Fits shoes up to approximately 85mm tall (Most slippers/water shoes)Plate 5: Holder X Small: Fits shoes up to approximately 70mm tall (Most flip flops/sliders)Plate 6: Leg Middle: You will need one of these for where 4 holders meet in the middle. Use the tall one if you are using flip flops or other shoes with a wide foot opening.Plate 7: Leg Edge: You will need one of these for where 2 holders meet around the outside. Use the tall one if you are using flip flops or other shoes with a wide foot opening.Plate 8: Leg Corner: You will need one of these for
Kategorie
Footwear
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Fortgeschritten Niedrige Konfidenz
Supports 1/3
Zusammenbau 2/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen