Modular Spice Rack

As I was looking a long time for a nice, handy spice rack with uptilted holders, I decided to create them myself.
The modules stack nicely on top of each other and are suited for glasses with:
max diameter: 60mm
min height 55mm
The tilt is 15° where the bottom of the rack does support the glasses fully. I did testprints and tried out which angle suits the best for me.
For easy mounting, I made screwholes for 4,5mm screws into the bottom support.

Printing:
300x300 print bed needed!
printed with 200°C, 50mm/s walls, 80mm/s for infill
Bed: 65°C initial layer, 60°C other layers
0,8mm floor & top layers, wall 1,2mm (gives it a lot of strength)
1Pcs takes around 200g of filament

You can glue the modules together or just mount each of them stacked. Additionally I liked the idea of beeing able to extend them, thats just a (long) print away :)