Modular Tree Shelf (Customizable)

Modular “Tree” Shelf Can be printed in pieces to virtually any heightCustomize spacing between shelves (50/75/100/150/200mm)Add extender pieces to create additional 200mm segments of heightCenter top shelf piece (150/200mm; add extender if you prefer)Easy to assemble; no glue, no hardware neededTwo Colour design with minimal filament swap (will print fine single colour)Assemble with shelves to the left and right, or make them spiral - whatever orientation you like. Model has been designed with fairly snug tolerances so it doesn't wobble too much. This means some force will be needed to put together and remove pieces. Printing Note: I use an A1 and would recommend a smooth or PEI plate for the base pieces, if you can keep the room a bit warmer that would be ideal as some warping may occur causing top layer printing artifacts. Will also likely want some glue around the corners of the model on the plate. The warmer printing temp appears to reduce warping. Those with an enclosed printe