Thingiverse
Modular Triptic Nespresso Sleeve Holder
von PsicoPete
137
Downloads
82
Likes
4
Makes
This is a remix from Nespresso cup dispenser / Nespresso Kapselspender by m4uli.
I modified the original 1 sleeve (box) stand and made it a modular holder, where you can add as much sleeves as you want.
One full set has 3 pieces: a Left end piece; a middle section you can multiply at will; and a Right end piece.
Each middle piece has two indentations on the left side and two keys on the right one so they can be precisely placed side by side. Both end pieces have either the indentations (right end) or the keys (left end) so they can also be set in place.
The other small indents scattered on the faces are for 3mmx1mm circular magnets so all the pieces stay in place.
I also added a few tear shaped holes throughout the pieces to reduce printing time and filament usage.
If you find anything wrong with this design please let me know.
I modified the original 1 sleeve (box) stand and made it a modular holder, where you can add as much sleeves as you want.
One full set has 3 pieces: a Left end piece; a middle section you can multiply at will; and a Right end piece.
Each middle piece has two indentations on the left side and two keys on the right one so they can be precisely placed side by side. Both end pieces have either the indentations (right end) or the keys (left end) so they can also be set in place.
The other small indents scattered on the faces are for 3mmx1mm circular magnets so all the pieces stay in place.
I also added a few tear shaped holes throughout the pieces to reduce printing time and filament usage.
If you find anything wrong with this design please let me know.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
