Thingiverse
Moebius ring
von pmaegerman
530
Downloads
533
Likes
6
Makes
A moebius ring, after a few trials, this is what worked for me :
shell 2mm
infill 20%
Support ( cura ) overhang angle : 50°
Printed at 70mm/s .2mm resolution.
I tried no infill, forget about it, you'll waste plastic ;)
1.2mm shell was too thin in some spots where the angle is very low.
How to design this in blender : https://www.youtube.com/watch?v=s6Jqb4dIV9g
shell 2mm
infill 20%
Support ( cura ) overhang angle : 50°
Printed at 70mm/s .2mm resolution.
I tried no infill, forget about it, you'll waste plastic ;)
1.2mm shell was too thin in some spots where the angle is very low.
How to design this in blender : https://www.youtube.com/watch?v=s6Jqb4dIV9g
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
